Filter
Top Products
A – Command Line Interface
Set Setup Command
59048-01 A A-41
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table A-12 describes the system configuration fields. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
TrapCommunity Trap community password that authorizes an SNMP agent to
receive traps. This is a write-only field. The value on the switch
and the SNMP management server must be the same. The
default is “public”.
AuthFailureTrap Enables or disables the reporting of SNMP authentication
failures. If enabled, a notification trap is sent when incorrect
community string values are used. The default is "False".
Table A-12. System Configuration Settings
Entry Description
Eth0NetworkAddress Internet Protocol (IP) address for the Ethernet port.
Eth0NetworkMask Subnet mask address for the Ethernet port.
Eth0GatewayAddress IP address gateway.
Eth0NetworkDiscovery Boot Method (1 - Static, 2 - Bootp, 3 - DHCP, 4 - RARP)
AdminTimeout Specifies the amount of time in minutes the switch waits
before terminating an idle Admin session. Zero (0)
disables the time out threshold. The default is 30, the
maximum is 1440.
SecurityEnabled Enables or disables the enforcement of account names
and passwords.
LocalLogEnabled Enables or disables the saving of log information on the
switch.
RemoteLogEnabled Enables (True) or disables (False) the recording of the
switch event log on a remote host that supports the
syslog protocol.
RemoteLogHost IPAddress The IP address of the remote host that will receive the
switch event log information.
Table A-11. SNMP Configuration Settings
Entry Description