Filter
Top Products
13
Daisy Chaining
Daisy chaining the DSP-4 outputs to additional amplifiers:
The DSP-4 has two XLR audio outputs, one for each channel. These outputs may be used for daisy-chaining the post-DSP signal to other
amplifiers or for monitoring purposes. The XLR outputs may be used for daisy-chaining even when the DataPorts are used for input/out-
put. Do not use Output Power Limiting when daisy chaining.
To daisy-chain the DSP output, connect the output jacks of the DSP-4 to the input jacks of the next amplifier. Then connect
the paralleled signal from the first amplifier to the second amplifier, and so on, up to a maximum of five amplifiers (including the output
DataPort if connected to an amplifier). Make sure that all interconnecting cables are balanced and connected properly.