Filter
Top Products
CHAPTER 2. INSTALLATION
ACTIVE Professional External Modem User’s Manual
8
Example to set up DTE speed 57600 bps and modulation V.22 bis,
1. Set
Normal / Config.
Switch to PUSH position for Config. mode.
2. Set desired DTE speed 57600 bps
Method:
Toggle the
Menu
Switch to Menu 4 (DTE speed menu), the digit ‘4’
is shown on the LED segment. Then toggle the
Function
Switch to
Function 2 (speed 57600 bps is selected), the digit ‘2’ is shown on the
LED segment. Then press the
Enable
Switch to update the DTE
speed, The character ‘U’ is shown on the LED segment and all
parameters will be saved to profile 0 automatically.
3. Set modulation V.22 bis
Method:
Toggle the
Menu
Switch to Menu 3 (modulation menu), the digit ‘3’
is shown on the LED segment. Then toggle the
Function
Switch to
Function 4 (V.22 bis is selected), the digit ‘4’ is shown on the LED
segment. Then press the
Enable
Switch to update the modulation
setting, the character ‘U’ is shown on the LED segment and all
parameters will be saved to profile 0 automatically.
4. If more settings are required (i.e tx level, flow control, etc), repeat the
above steps. The above features were saved to profile 0
automatically).
5. To finish configuration by setting the
Normal / Config.
Switch to
POP position.