Filter
Top Products
3 Hardware Installation
1. Turn off the power of the computer system in which the QSC(LP)-200/300 is to be
installed.
2. Remove the system cover according to the instructions provided by the computer
manufacturer.
3. Make any desired optional jumper setting changes.
4. Install the QSC(LP)-200/300 in any empty PCI expansion slot. The board should be
secured by installing the Option Retaining Bracket (ORB) screw.
5. Replace the system cover according to the instructions provided by the computer
manufacturer.
6. Attach and secure the cable connectors to the desired equipment.
7. Turn on the power of the computer system.
The output of the QSC(LP)-200/300 is a 44-pin custom connector,
which is brought out to four 9-pin D-connectors via a custom cable.
J1
Figure 3 --- Jumper/connector locations
Quatech QSC(LP)-200/300 User's Manual 8