Filter
Top Products
Chapter 5 Setup Menu FCD-IPM Installation and Operation Manual
5-32 Interface Parameters Menu
E1 Interface
Loopback
FCD-IPM
SHDSL Interface
Figure 5-36. Local Loopback
E1 Interface
Loopback
FCD-IP
M
SHDSL Interface
E1
Service
Figure 5-37. Remote Loopback
.
• Make sure that the SHDSL link is operating properly before running the remote
loopback.
• Do not activate local loopback from the E1 Setup menu, when FCD-IPM is
equipped with E1 over SHDSL interface.
E1/T1 Settings
Select this option to configure the E1 or T1 parameters. The T1 parameters are
described in the T1 Setup Menu section on page 5-35 and the E1 parameters are
described in the E1 Setup Menu section on page 5-51.
FCD-IPM is an integrated router/bridge with E1/T1 and fractional E1/T1 services.
FCD-IPM is available in several options (refer to Figure 5-38, Figure 5-39 and
Figure 5-40)
For Example:
• T1
• T1 with sublink
• E1
• E1 with sublink
• E1 or T1 with analog voice ports.
Note
Advanced Menu
↓1
Setup Menu
↓3
Interface Parameters Menu
↓2
E1/T1 Settings Menu