Filter
Top Products
CHAPTER 13: KX II LOCAL CONSOLE 139
3. Select the Local Port Hotkey. The Local Port Hotkey is used to return to the KX II Local
Console interface when a target server interface is being viewed. The default is Double Click
Scroll Lock, but you can select any key combination from the drop-down list:
HOTKEY: TAKE THIS ACTION:
Double Click Scroll Lock Press Scroll Lock key twice quickly
Double Click Num Lock Press Num Lock key twice quickly
Double Click Caps Lock Press Caps Lock key twice quickly
Double Click Left Alt key Press the left Alt key twice quickly
Double Click Left Shift key Press the left Shift key twice quickly
Double Click Left Ctrl key Press the left Ctrl key twice quickly
4. Set the Video Switching Delay from 0 – 5 seconds, if necessary. Generally 0 is used unless
more time is needed (certain monitors require more time to switch the video).
5. If you would like to use the power save feature:
a. Check the Power Save Mode checkbox.
b. Set the amount of time (in minutes) in which Power Save Mode will be initiated.
6. Select the Resolution for the KX II Local Console from the drop-down list:
800x600
1024x768
1280x1024
7. Select the Refresh Rate from the drop-down list:
60 Hz
75 Hz
8. Select the type of Local User Authentication:
Local/LDAP/RADIUS. This is the recommended option; for more information about
authentication, refer to Remote Authentication
and Authentication vs. Authorization.
None. There is no authentication for local console access. This option is
recommended for secure environments only.
9. Check the Ignore CC managed mode on local port checkbox if you would like local user
access to the Dominion KX II even when the device is under CC-SG management.
Note: If you clear this checkbox but then want local port access, you will have to remove the
device from under CC-SG management (from within CC-SG) and then you will be able to
check this checkbox.
10. Click OK.
To close the page without saving any changes:
Click Cancel.
To reset back to defaults:
Click Reset to Defaults.