Filter
Top Products
CHAPTER 2: INSTALLATION 5
Connecting the Converter to a KVM Switch
To connect the converter to a Raritan Dominion KX II or Paragon KVM switch:
1. Take a standard Category 5e UTP cable and connect one end to the RJ45 connector on the
P2CIM-SER or P2CIM-SER-EU.
2. Connect the other end of the cable to a channel port on the KVM switch.
Installation is now complete. You can now access and operate the ASCII device using the
switch’s monitor and keyboard.
Note: The maximum cable length of the converter varies depending on the type of the KVM switch
being connected. See the user guide of the specific KVM switch for the cable length limitation.
These user guides are available on Raritan’s Product Documentatin
w
eb page:
http://www.raritan.com/support/productdocumentation
.