Filter
Top Products
Chapter 4
Voice over IP
E-DOC-CTC-20050401-0008 v1.0
48
4.1 Telephony Setup
Telephony installation The SpeedTouch™ is equipped to connect one or two analogue phones or faxes.
Use a phone cable with RJ-11 connectors to:
1 Wire the SpeedTouch™ Phone port(s) to your phone(s) or fax.
2 Wire the SpeedTouch™ PSTN port to your telephone wall outlet or distributed
filter depending on your Service Provider’s specific needs.
Telephony configuration The telephony service might already have been configured on your SpeedTouch™
during initial setup.
If the service hasn’t been configured yet, follow the instructions hereunder:
Enable the telephony service
Assign phone numbers
Configure the telephony service
This is only required if you still want to make phone calls using the
regular telephone line.
!
Be aware that if the PSTN port is not wired to your telephone wall
outlet or distributed filter, emergency calls will not always be possible!
Your Internet connection must be up, to be able to configure Internet
telephony.