Filter
Top Products
Chapter 4
Voice over IP
E-DOC-CTC-20050401-0008 v1.0
55
Using the services on
the phone
In following table the procedures are shown of how to use a telephony service. The
commands are depending on your provider’s configuration, so might be different
from the ones described here. For more information, see your provider’s
documentation.
Make sure your phone is off hook while dialing the commands.
If your phone hasn’t got an R or another hook flash button, put down the
hook for 1/2 second and then dial the command number.
To use the service: Proceed as follows:
Call Hold To put person A on hold:
1 Dial R, 2 to put the call with person A on hold.
2 Dial R, 1 to retrieve the call on hold.
To put person A on hold and set up a call to person
B:
1 Dial R, 2 to put the call with person A on hold.
2 Wait for the dial tone, and dial the number of
person B.
3 Dial R, 2 to switch back to person A. Person B
is put on hold.
Call Waiting You are in a phone conversation with person A
while person B is calling you. The phone produces
a waiting tone and - if CLIP is enabled and CLIR
disabled - displays the number of person B on the
display.
To reject the incoming call, dial R, 0.
To terminate the first call and to switch to the
waiting call, dial R, 1.
If you do not want to terminate the first call,
dial R, 2 to keep the first caller on hold while
answering the second call.
To return to person A while putting
person B on hold, dial R, 2.
To return to person A while terminating
the call with person B, dial R, 1.
Call Transfer You receive a phone call from person A and you
want to transfer him to person B.
1 Dial R, 2.
2 Wait for the dial tone.
3 Dial the number of person B.
4 Person B picks up the phone.
5 Dial R, 4 to transfer the call.
6 Hang up the phone.