Filter
Top Products
Chapter 4
Voice over IP
E-DOC-CTC-20050401-0008 v1.0
56
Command overview In the table below all standard service codes of the telephony services are listed. On
your SpeedTouch™ these might be different, depending on your provider.
Conference Call (3 Party) To set up a conference call:
1 Call person A.
2 Dial R, 2. Person A is put on hold.
3 Wait for the dial tone.
4 Dial the number of person B.
5 Person B picks up the phone.
6 Dial R, 3.
Once the conference call has been established, you
can:
1 Dial R, 2 to put the 2 calls on hold.
2 Dial R, 3 to retrieve the 2 held calls.
CLIR on call basis It is possible to hide your phone number for one
particular call. Dial *31* directly followed by the
phone number of person A.
Forced FXO To make a phone call over the regular telephone
line:
1 Dial *01*.
2 Wait for the dial tone, and then dial the phone
number of person A.
To use the service: Proceed as follows:
Phone command: Is used to:
R 0 drop a held call
reject an incoming call
R 1
terminate an active call and switch to the
waiting or held call
R 2
put a call on hold
switch between active and waiting or held call
put a conference call on hold
R 3
establish a 3-way conference call
R 4
transfer a call
*31*
make an anonymous call (use CLIR) on call
basis
*01*
use the regular telephone line