Renesas M16C/6N4 Network Card User Manual


 
M306NKT-EPB User’s Manual 3. Usage (How to Use the Emulator Debugger)
REJ10J0519-0200 Rev.2.00 Oct. 16, 2006 Page 47 of 104
3. Usage (How to Use the Emulator Debugger)
This chapter describes how to start up the emulator debugger from the High-performance Embedded Workshop.
3.1 Starting Up the Emulator Debugger
When debugging the completed programs, switch the session. The session can be changed by the drop down list of the tool bar
shown below.
You will have as many sessions created as the number of targets you selected when creating a project, so select the session that
corresponds to the target to be connected from the drop-down list. Select “SessionM16C_R8C_PC7501_Emulator” in the list.
3.1.1 INIT Dialog Box
After specifying the session, an Init dialog box to connect the target is displayed. The Init dialog box is used to set the items
that need to be set when the emulator debugger starts up. The contents set in this dialog box remain effective the next time you
start the debugger.