Renesas M16C/6N4 Network Card User Manual


 
M306NKT-EPB User’s Manual 5. Troubleshooting
REJ10J0519-0200 Rev.2.00 Oct. 16, 2006 Page 96 of 104
5. Troubleshooting
This chapter describes how to troubleshoot when this product does not work properly.
5.1 Flowchart to Remedy the Troubles
Figure 5.1 shows the flowchart to remedy the troubles from when power to the emulator is activated until the emulator
debugger starts up. Check this while the user system is disconnected. For the latest FAQs visit the Renesas Tools Homepage.
http://www.renesas.com/en/tools
Turning on PC7501
Upper panel LED
of PC7501
1. Check the connection of power supply cable.
See 2.5 Connecting the Power Supply for the Emulator
(page 25).
2. Check that the power is properly supplied to the use system.
See
2.7 Downloading Firmware
(page 28).
3. Restart the emulator system.
Init dialog box of emulator
debugger displayed
1. Check the operating environment etc. of the emulator
debugger.
See the user
s manual of the emulator debugger.
2. Reinstall the emulator debugger.
MCU Setting dialog box of
emulator debugger
See “5.2.(2) MCU Setting Dialog Box Does Not Appear at
Emulator Debugger Startup (page 98).
Program window of emulator
debugger displayed
See “5.2.(3) Errors Occur at Emulator Debugger Startup(page 99).
Emulator debugger startup completed
Normal
Normal
Normal
Normal
Not normal
Not normal/Error displayed
Not normal/Error displayed
Error displayed
Figure 5.1 Flowchart to remedy the troubles