Filter
Top Products
M306NKT3-RPD-E User’s Manual 2. Setup
REJ10J0326-0400 Rev.4.00 Sep. 01, 2006 Page 46 of 104
Table 2.4 Switch settings of the M306NKT3-RPD-E (2)
Signal Switch Setting Description
Xout
OP Xout
SW3
(factory-settings)
Does not connect pin Xout of the MCU to the user system.
Xout SW3
Xout
OP Xout
SW3
Connects pin Xout of the MCU to the user system.
P86/Xcout
P86/XC OP
SW4
(factory-settings)
Connects pin P86/Xcout of the MCU to the user system to use it as
port P86 or Xcout.
P86/Xcout SW4
P86/Xcout
SW4
P86/XC OP
Does not connect pin P86/Xcout of the MCU to the user system.
P87/Xcin
P87 Xcin
SW5
(factory-settings)
Connects pin P87/Xcin of the MCU as port P87.
P87/Xcin SW5
P87/Xcin
P87 Xcin
SW5
Connects pin P87/Xcin of the MCU as Xcin.
CAUTION
Note on Switch Settings:
Always shut OFF power before changing switch setting.
IMPORTANT
Note on BYTE and CNVss Switch Settings:
Switch settings of the BYTE and CNVss are for debugging without the user system connected.