Filter
Top Products
RF Neulink
NL6000 User Guide
19
Consider the following example of a repeater (MYID3000) configured to
repeat packets transmitted from a base station (MYID2000) to a hidden
remote (MYID4203). Unit MYID3000 is configured with a repeater entry
that has a Trigger = TOID and ID = 4203. This entry tells unit MYID3000
to listen for packets that have a destination address of TOID4203. If the
repeater receives a packet matching the criteria, it immediately repeats
the packet. Figure 10 illustrates this scenario.
Figure 10: Repeat from a Base to a Remote
Consider the following example of a repeater (MYID3000) configured to
repeat packets transmitted from a hidden remote (TOID4201) to a base
station (TOID2000). Unit MYID3000 is configured with a repeater entry that
has a Trigger = MYID and ID = 4201. This entry tells unit MYID3000 to
listen for packets that have a source address of MYID4201. If the repeater
receives a packet matching the criteria, it immediately repeats the packet.
Figure 11 illustrates this scenario.
Figure 11: Repeat from a Remote to a Base Station
Because MYID and TOID values may use wildcards, it is possible to set up
a single repeater entry that will repeat all packets destined to a group of
hidden remotes. In Figure 12, a repeater entry with a Trigger = TOID and ID
= 42FF repeats any packet with a destination matching TOID42FF.