Filter
Top Products
CARETAKER PLUS INSTALLATION AND OPERATIONS MANUAL
27
Print Configuration/Test Pattern Function
Holding both switches down at the end of test 4 causes the unit to print its configuration
out to port O, as shown in TABLE 8. Holding both switches down a second time at the
end of test 4 causes a print exerciser to run, which sends a repeating test pattern out to
the device on port O. To stop the exerciser, press both switches again. The exerciser
may be started and stopped again the same way. The exerciser follows the protocol
assigned to port O.
Table 8 Print Configuration
Serial Units
CARETAKER PLUS CONFIGURATION Rev 3.8 COPYRIGHT 1986-91 ROSE
ELECTRONICS
Installed memory 64K Front panel switches … ENABLED
Timeout ........········ 20 Seconds Form feed ......... DISABLED
Initialization String .. DISABLED
....-. Current settings -----
Port Baud Parity Length Stop Flow
0 9600 NONE 8 1 DTR
1 9600 NONE 8 1 DTR
2 9600 NONE 8 1 DTR
3 9600 NONE 8 1 DTR
4 9600 NONE 8 1 DTR
Unidirectional Xon/Xoff .············ ENABLED
Reverse Channel Data Timeout…… DISABLED
Allow Timeout On Busy (Ports 1-8) ... Yes
Filter size ............·········--·· 0 Characters
Parallel Units
CARETAKER PLUS CONFIGURATION ReV 3.8 COPYRIGHT 1986-81 ROSE
ELECTRONICS
Installed memory ....··· 64K Front panel switches.. ENABLED
Timeout .........---- 20 Seconds Form feed .......······ DISABLED
Initialization String .. DISABLED
Ignore ACK .... NO
Ignore BUSY ... NO
Parallel Enable Logic ... ENABLED