Filter
Top Products
Installation
Runco CL-810 Series Owner’s Operating Manual 23
PRE
L
IMINAR
Y
Remove Projector Front
Feet
Place the projector upside down on a blanket
or other soft surface. Then, remove the two
front feet by turning them counter-clockwise.
Install Lens Motor
Mounting Plate and
Ceiling Mount
Adapters/Projector
Stands
For ceiling installations, the adapters bring the mounting points for the projector mounting
plate (included with the ceiling mount kit) from the bottom of the projector up and around
the lens motor housing. For floor installations (where the projector is upright), the adapters
allow the projector to lie flat on the mounting surface.
1. Assemble the AutoScope lens motor mounting plate
(item #7) and ceiling mount adapter/projector stands
(items #3 and #4) as shown in
Figure 3-7. Note that the
“tongue” at the front of each adapter/stand fits under
the metal folds on the lens motor mounting plate.
2. Using the supplied, M6 x 16mm flat-head Phillips
screws (item #1), attach the AutoScope lens motor
mounting plate (item #7) and ceiling mount adapter/projector stands (items #3
and
#4) to the projector as shown in Figure 3-7.
3. Secure the ceiling mount adapter/projector stands at the rear using the supplied,
M6
x 12mm pan-head Phillips screws (item #2).
Figure 3-7. CL-810 Ultra with Lens Motor Mounting Plate and Ceiling Mount
Adapters/Projector Stands
1
2
3