Filter
Top Products
Controls and Functions
Runco VX-2000d Owner’s Operating Manual 15
PRE
L
IMINAR
Y
2.6
VX-2000d Built-In
Keypad
The VX-2000d has a built-in keypad that you can use to access the menu system for
working with digital 1080i or 1080p sources.
Figure 2-6 shows the VX-2000d built-in
keypad; the paragraphs that follow describe its use.
Figure 2-6. VX-2000d Built-In Keypad
1. RETURN
Press RETURN to exit the current menu or cancel an operation.
2. ENTER
Press ENTER to confirm a menu item selection.
3. DOWN / UP / LEFT / RIGHT
Use these buttons to select menu items or adjust settings.
4. MENU
Press MENU to display or hide the OSD menus for digital 1080i or 1080p sources.
5. (not used)
6. STANDBY
Press STANDBY to put the projector into standby mode.
7. ON
Press ON to turn the projector on or off.
Only trained service personnel should use the built-in
keypad. Almost all projector configuration and operational tasks
can be performed using the DHD Controller.
It is only necessary to use the built-in keypad if IR signals from the
remote control cannot reach the DHD Controller, or for performing
service-related tasks such as resetting the lamp hour counter (refer
to
Lamp Replacement on page 63).
RETURN ENTER DOWN UP LEFT RIGHT
RETURNENTERDOWNUPLEFTRIGHT
ON
ON
MENU
MENU
ASPECT
RATIO
ASPECT
RATIO
STANDBY
STANDBY
13 45
2
7
6
Note