Runco VX-2IX Projector User Manual


 
Installation
Runco VX-2ix Owner’s Operating Manual 25
RS-232 Controller
Connection
Use a standard, 9-pin RS-232 cable to connect a PC or home theater control/automation
system (if present) to the RS-232 CONTROL port on the VX-2ix; see
Figure 3-10.
For more information about using this connection, refer to Serial Communications on
page 51.
Figure 3-10. RS-232 Control System Connection
Connecting 12-Volt
Trigger Outputs to
External Theater
Equipment
If your VX-2ix is equipped with a CineWide with AutoScope system, use the cable
supplied with the AutoScope Lens Motor to connect the motor to a 12-Volt trigger output
as shown in
Figure 3-11.
Figure 3-11. Connecting the 12-Volt Trigger Output to the AutoScope Lens Motor
COMPONENT VIDEO
Pb
Pr Y
COMPONENT VIDEO
Y
Pr
Pb
VIDEO
VIDEO
S-VIDEO 2
S-VIDEO 2
S-VIDEO 1
S-VIDEO 1
RS-232
CONTROL
RS-232
CONTROL
IR
IR
12
3
1
23
TRIGGERS
TRIGGERS
1
2
345
7
89
6
to Automation/
Control System
or PC
2 Transmit Data
3 Receive Data
5 Ground
(none of the other pins are used)
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 OutComponent Video
3.5-mm
mini plug
to AutoScope
Lens Motor