Filter
Top Products
Runco VX-2ix Owner’s Operating Manual 27
4.1
Turning on the Power
1. Turn on your source components.
2. Turn on the main power switch on the projector.
3. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input.
4. Press the ON button on the remote control – or the POWER button on the VX-2ix
rear panel – to turn on the projector. The vacuum fluorescent display on the VX-2ix
rear panel briefly displays “Starting Display.”
5. When the projector is ready for use, the fluorescent display indicates the active
source, signal format (NTSC or PAL), input resolution and aspect ratio; for example:
4.2
Adjusting the Picture
Orientation
By default, the VX-2ix is configured for a “floor/front” installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or
mounted on a ceiling, you must change the picture orientation. To do this:
1. Press MENU and enter the Service Menu passcode.
2. Select Service from the Main Menu.
3. Select Display Device from the Service Menu.
4. Select Installation from the Display Device menu.
5. Choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the installation method.
4. Operation
Component SD NTSC 480i
Anamorphic VX-2
Current Source Format
Input
Resolution
Aspect
Ratio
You must enter a passcode to access the Service menu.
Note