Filter
Top Products
36
Using "Central Station"
2
2 Using "Central Station"
network information such as the IP address to the PC, and the transmitted network information is
automatically registered to the network settings on the PC. The DHCP service is convenient and useful
especially in an environment where multiple PCs are used. Theoretically, the IP address changes each
time the PC boots up (or an IP allotment request is sent); in many cases, however, the existing IP address
is re-allotted. An Internet router performs two roles: creating a private IP address (NAT service) and
automatically allotting the IP address to each PC (DHCP service) at the same time.
When using your Central Station monitor’s or notebook PC’s LAN network, ensure you insert a LAN
cable into only one device. Otherwise, a system crash may occur.
Dynamic IP User
1 To use a dynamic IP address, connect a LAN to your Central Station monitor.
2 Next, go to the network settings menu and activate the Central Station monitor’s network device
(select “Use”).
Go to Control Panel Network and Internet Network and Sharing Center Change
adapter settings. Next, right-click on the Central Station monitor’s network device (marked
“LAN9512/LAN9514 USB 2.0 to Ethernet 10/100 Adapter #7”) and select Use.
3 Using the network properties menu, check that the IP address mode for the Central Station
monitor’s network device is set to Auto.
Go to Control Panel Network and Internet Network and Sharing Center Change
adapter settings. Next, right-click on the Central Station monitor’s network device (marked
“LAN9512/LAN9514 USB 2.0 to Ethernet 10/100 Adapter #7”).