Filter
Top Products
Spinpoint
M8 Product Manual REV
2.3
36
CHAPTER 6 SATA II INTERFACE
6.1 Introduction
The Spinpoint M8 disk drive is equipped with an industry standard SATA Interface fully supports and enhances
PC mass storage requirements. The SATA interface conforms to the Serial ATA standards in Cabling, in Physical
Signals, and in Logical Programming schemes. The Spinpoint M8 disk drive joins the industry premiere VLSI
circuitry with ingenious programming skill that does not compromise performance or reliability. Samsung
integrates and delivers the cutting edge in technology. Samsung Spinpoint M8 SATA class disk drives are
designed to relieve and to enhance the I/O request processing function of system drivers.
SATA Terminology
The following contains some commonly proposed terminology used in SATA technology.
BACKCHANNEL-A term used to describe or refer to the transmit same-side of SATA interface, when the
scope of the paragraph is addressing the receive interface. For example, when di
scussing the receive SATA
interface on the device side, the term “backchannel” would be used to describe the transmit interface on the
device side.
CHARACTER ALIGNMENT-Character alignment is a receiver action that resets the character boundary to
that of the comma sequence found in the K28.5 control character of the ALIGN primitive, and establishes
Dword synchronization of the incoming serial data stream.
CHARACTER SLIPPING-Character slipping is the receiver action that realigns the receiver’s clock to the
received
bit stream by adding or removing bit times within the characters of the ALIGN primitive.
CODE VIOLATION- A code violation is an error that occurs in the reception process as a result of (1) a
running disparity violation or (2) an encoded character that does not translate to a valid data or control
character or (3) an encoded character that translates to a control character other than K28.5 or K28.3 in byte 0
of a Dword or (4) an encoded character that translates to any control character (valid or invalid) in bytes 1-3
of a Dword.
COMMA CHARACTER- A comma character is a control character, that when encoded, contains the
comma sequence. In Serial ATA the only comma character used is K28.5, and only the ALIGN primitive
contains the comma character. The comma sequence is the first seven bits of the encoded character.
COMMA SEQUENCE- The comma sequence is a seven-bit sequence of 0011111 or 1100000 in an encoded
stream. The comma sequence is unique in that it appears only in a single encoded character, and fur
thermore,
cannot appear in any subset of bits in adjacent encoded characters. This unique property allows the comma
sequence to be used for determining alignment of the received data stream.
COMRESET / COMINIT- Host: Signal from the out of band detector that indicates the COMINIT out of
band signal is being detected.
CONTROL CHARACTER- A control character is a combination of a byte value with the control variable
equal to K.