Filter
Top Products
e-20
Resetting Channels
1) Press the SET button. The border of the selected channel will blink.
2) Press the ENTER button at the center of the Rotary Wheel. Now, you can change to your
desired channel.
3) Move to your desired channel using the Rotary Wheel and press ENTER to complete
changing the channel.
4) If you want to reset to another channel, use the Rotary Wheel to move to the channel you
want to change and the border of the selected channel will blink.
5) Repeat steps 2) and 3). When the resetting is completed, press the SET button.
The MULTISCREEN button will not operate in the following cases:
• While using the SETUP Menu
• While displaying the Event List or Door Bell List
• While replaying events
• While zooming-in the screen
• While setting a split screen
5. When you want to watch in Sequence Screen Mode.
The Sequence screen is available only in full-screen LIVE mode. Press the SEQUENCE
button when the screen is in full-screen LIVE mode to switch to the Sequence screen. You
can set the switching intervals by going to "SEQUENCE" under "4. SYSTEM SETTING" on
the SETUP MENU. The range of switching intervals is from one to thirty seconds. Press the
SEQUECE button again to stop the screen displayed at the present time.
The SEQUENCE button will not operate in the following cases:
• While operating in P.B. or TRIPLEX mode
• While using the SETUP Menu
• While setting or displaying a split screen
• While displaying the Event List or Door Bell List
• While replaying events
• While zooming-in the screen
1_SMO-210TP_E 10/18/02 5:19 PM Page e-20