Filter
Top Products
●
Remove the screw (BH M2. 6) at the bottom of the main unit by turning it
counterclockwise, and then lift the assy-case front as you push it upward to detach
it from the case-rear.
(✳ Do not apply excessive force, as doing so may damage the inside assembly.)
●
Place the case-rear over the installation site and mark screw holes with a pencil
(indicated by the red circles in the illustration). Drill a pilot hole for each pencil
mark (5mm in diameter and at least 35mm in depth), and then fully insert the
supplied plastic anchors (HUD 5) into them.
14
Assy-case front
BH M2. 6
CASE-REAR