Filter
Top Products
47
Setting
Power management
For reducing power consumption as well as
maintaining the lamp life, the Power management
function turns off the projection lamp when the
projector is not used for a certain period.
When the input signal is interrupted and no button is
pressed for more than 30 seconds, the timer display
with "No signal" appears. The countdown starts to turn
off the lamp.
Select one of the operations:
Ready. . . . . . . . When the lamp has been fully
cooled down, the POWER indicator
changes to green blinking. In this
condition, the projection lamp
is turned on if the input signal is
reconnected or any button on the
top control or remote control is
pressed.
Shut down
. . . . When the lamp has been fully
cooled down, the power is turned
off.
Off
. . . . . . . . . . Power management function is off.
Then set the countdown timer with the Point 7 8
buttons.
Time left before Lamp is off.
Press the SELECT button
at Power management and
this box appears. Choose
one of three settings with
the Point 7 8 buttons, and
go to the timer with the
Point ed buttons and set
time with the Point 7 8
buttons.
Power management
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the
back of the projector is switchable for computer input
or monitor output. (See page 9) Select Computer 2 or
Monitor Out with the Point 7 8 buttons.
Computer 2 . . . . . . computer input
Monitor Out
. . . . . . monitor out
Terminal function is not available when selecting
Computer 2 to the input source. Change the input
source to the others (Computer1 or Video) so that the
Terminal function will be available. (p.25, 35, 36)
✔ Note:
Factory default is " Ready, 5 min".