Filter
Top Products
SettingSetting
46
Power management
For reducing power consumption as well as
maintaining the lamp life, the Power management
function turns off the projection lamp when the
projector is not used for a certain period.
When the input signal is interrupted and no button is
pressed for more than 30 seconds, the timer display
with "No signal" appears. The countdown starts to turn
off the lamp.
Select one of the operations:
Ready. . . . . . . . When the lamp has been fully
cooled down, the POWER indicator
changes to green blinking. In
this condition, the projection lamp
is turned on if the input signal is
reconnected or any button on the
top control or remote control is
pressed.
Shut down . . . . When the lamp has been fully
cooled down, the power is turned
off.
Off . . . . . . . . . . Power management function is off.
Then set the countdown timer with the Point 7 8
buttons.
Time left before Lamp is off.
Press the SELECT
button at Power
management and this
box appears. Choose
one of three settings
with the Point 7 8
buttons, and go to the
timer with the Point
ed buttons and set
time with the Point 7 8
buttons.
Power management
✔
Note:
Factory default is “Ready: 5 min.”