Sanyo PLC-XW55A Projector User Manual


 
Appendix
57
Appendix
Some displays are not seen
during operations
Check the Display item. (See page 42.)
The Remote Control does not
work
Check the batteries.
Make sure there is no obstruction between the projector and
remote control.
Make sure you are not too far from the projector when using
the remote control. Maximum operating range is 16.4' (5 m).
Make sure the code of the remote control is conformed to that
of the projector. (See page 47.)
Unlock the Key lock function for the remote control. (See page
48.)
PIN code dialog box appears at
the start-up
PIN code lock is being set. Input a PIN code (1234 or numbers
you have set). (See pages 18, 48, and 49.)
WARNING:
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you
purchased the projector or the service center. Specify the model number and explain about the
problem. We will advise you how to obtain service.
This symbol on the nameplate means
the product is Listed by Underwriters
Laboratories Inc. It is designed and
manufactured to meet rigid U.L. safety
standards against risk of fire, casualty and
electrical hazards.
The CE Mark is a Directive
conformity mark of the
European Community (EC).
Pixelworks ICs used.
No sound
Check audio cable connections from the audio input source.
Adjust the audio source.
Press the VOLUME + button. (See page 23.)
Press the MUTE button. (See page 23.)
– Is the image projected? You will hear the sound only when the
image is projected.