Filter
Top Products
13
CONNECTING THE PROJECTOR
––––––––
ADB
––––––––
––––––––
––––––––
––––––––
––––––––
––––––––
GND
––––––––
––––––––
––––––––
Serial Port
ADB Port
1
2
3
4
5
6
7
8
9
10
11
12
PS/2 Port
T x D
––––––––
––––––––
––––––––
––––––––
––––––––
READY
––––––––
GND
––––––––
––––––––
––––––––
––––––––
CLK
DATA
––––––––
––––––––
––––––––
––––––––
––––––––
GND
––––––––
––––––––
––––––––
CONNECTING THE COMPUTER
Personal computers can be connected to the HDB15-pin (VGA) terminal on the projector.
● Connect the computer to these terminals using the VGA cable and VGA/MAC adapter (provided).
CAUTION: For projectors, the VGA cable provided is designed to reduce RFI (Radio Frequency Interference) emissions.
For regulatory compliance reasons, this cable must be used and must not be replaced by any other cable.
Digital output signal from the computer can be connected to the DIGITAL terminal (MDR 20-pin). When using this input,
Graphic Accelerator Board designed for this projector should be installed into your computer and set-up the computer
configuration following instruction included in the Graphic Accelerator Board package. Refer to DIGITAL INPUT
CONNECTION on page 16 and 18.
Personal computers can be connected to the computer input (Red, Green, Blue, Horiz. Sync. and Vert. Sync.) on the
projector.
● Connect the computer to these jacks using the BNC cables (not provided).
● Connect audio outputs from your computer to these jacks using the audio cable (not provided).
● When the computer is operated by projector's remote control unit, connect three different type of cables (provided)
between projector control port and computer mouse port or serial port.
1
4
3
7
8
11
12
9
10
2
5
6
■ CONTROL PORT
AA
B
CONTROL PORT CABLE REMOVAL
HINT
Disconnect control port cable with
following steps.
1. Hold the portion (A)
of the connector
with one hand.
2. Pull the portion (B)
arrow direction and
remove connector.
CONNECTING TO THE COMPUTER INPUT 1 TERMINAL (ANALOG HDB 15-PIN)
CONNECTING TO THE COMPUTER INPUT 1 TERMINAL (DIGITAL MDR 20-PIN)
CONNECTING TO THE COMPUTER INPUT 2 JACKS (BNC x 5)
CONNECTING TO THE COMPUTER AUDIO INPUT JACKS (1 and 2)
CONNECTING TO THE MULTI-POLE 12-PIN (CONTROL PORT) CONNECTORS (1 and 2)
COMPUTER TYPE
IBM Compatible computer with PS/2 mouse port.
IBM Compatible computer with serial port.
Apple Macintosh computer with ADB mouse port.
CABLE
Mouse Cable for PS/2 port.
Mouse Cable for Serial port.
Mouse Cable for ADB port.