Filter
Top Products
19
Connect the projector's AC Power Cord into an AC outlet. The
POWER indicator flashes in a moment and then turns red.
Press POWER ON-OFF button on the top control or the remote
control. The POWER Indicator turns green, and the cooling fans
start to operate. The starting display appears on the screen and
the count-down starts.
2
3
Tu r ning Off the Projector
Press the POWER ON-OFF button on the top control or the
remote control, and the message " Power off? " appears on the
screen.
Press the POWER ON-OFF button again to turn off the
projector. The POWER indicator starts to flash red and continues
while the cooling fans are operating. (for approx. 90 seconds)
1
2
TO MAINTAIN THE LIFE OF LAMP, ONCE YOU TURN
PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE
TURNING IT OFF.
DO NOT DISCONNECT THE AC POWER CORD WHILE
COOLING FANS ARE RUNNING OR BEFORE POWER
INDICATOR LIGHTS RED. OTHERWISE IT WILL RESULT IN
SHORTENING LAMP LIFE.
Tu r ning On the Projector
1
Complete peripheral connections (with a computer, VCR, etc.)
before turning on the projector.
3
When the projector is cooled down enough to be turned on
again, the Power indicator turns red again. Then you can
disconnect the AC power cord.
26
– The starting display disappears after 30 seconds.
– The starting display can be changed. (
☞
" Capture " P36 )
Power off?
Message disappears after 4 seconds.
Basic Operation
After the count-down, the input source that was selected last
and the Lamp mode status appear on the screen.
4
Note :
– When the Power Management function is ON, the projector detects signal
interruption and automatically turns off the projection lamp. (
☞ P 37 )
– The projector cannot be turned on during the cooling period with the
POWER indicator flashing red. You can turn it on again after the POWER
indicator lights red.
– Do not use the projector for more than 24 hours continuously. Turn off the
projector at least once in 24 hours and give it a rest. Continuous use may
result in shortening the lamp lifetime.
– This projector detects internal temperature and automatically controls the
running speed of the cooling fans.
– If the WARNING indicator flashes or lights red, see “Warning Indicator” on
page 42
(
☞
" Lamp mode " P37 )
Selected Input Source and Lamp Mode
Lamp mode