Filter
Top Products
On start
When this function is “On,” the projector is automatically turned on
just by switching the MAIN ON / OFF SWITCH on.
Note ; Be sure to turn the projector off properly (refer to the section
“TURNING OFF THE PROJECTOR” on page 20.). If the
projector is turned off in the wrong steps, the On Start
function does not operate properly.
36
SETTING
SETTING MENU
Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT buttons to select
SETTING and press the SELECT button. Another dialog box
SETTING MENU will appear.
Press the POINT DOWN button and a red-arrow icon will
appear. Move the arrow to the item that you want to set, and
then press the
SELECT button to set it "On" or "Off" or press the
POINT LEFT/RIGHT button to adjust the value.
1
2
Blue back
When this function is “On,” this projector will produce a blue image
instead of the video noise on the screen when the input source is
unplugged or turned off.
Display
This function decides whether to display the On-Screen Displays.
On1 ···shows all the On-Screen Displays.
On2 ···shows the On-Screen Displays except the Preparation
Display (Our Logo).
Off ···· sets the On-Screen Displays disappeared except;
● ON SCREEN MENU
● “Power off?” message
● P-TIMER
Set the Pointer to the item
and press the SELECT
button.
This function turns the Projection Lamp off when the projector
detects signal interruption and the projector is not used for a certain
period in order to reduce power consumption and maintain the Lamp-
life. (This projector is shipped with this function ON.)
Power Management function operates to turn the Projection Lamp off
when the input signal is interrupted and the projector is not operated
over 5 minutes. This function operates as follows;
1. When the signal is interrupted, “No signal” and the counting
down (5 minutes) display appears.
2. When the Projection Lamp turned off, the READY indicator
turns off. The Cooling Fans operate for 90 seconds after the
Projection Lamp is turned off. (During this "Cooling Down"
period, the Lamp cannot be turned on.)
3. When the Lamp has cooled down, the READY indicator flashes
and the Lamp can be turned on again (Power Management
mode).
In this Power Management mode, the Projection Lamp is
automatically turned on when the input signal connected or the
projector is operated with any button on the Top Control or the
Remote Control.
Power management
Time left until Lamp off.