Filter
Top Products
37
The Lamp age function is designed to reset the lamp replacement
monitor timer. When replacing the lamp, reset the lamp replacement
monitor timer by using this function. (Refer to page 40.)
Lamp age
SELECTING LANGUAGE
Press the MENU button and the ON-SCREEN MENU will
appear. Press POINT LEFT/RIGHT buttons to select
LANGUAGE and press the SELECT button. Another dialog box
LANGUAGE MENU will appear.
Press the POINT DOWN button and a red-arrow icon will
appear. Move the arrow to the language that you want to set,
and then press the
SELECT button.
1
2
The language used in the ON-SCREEN MENU is selectable
from among English, German, French, Italian, Spanish and
Japanese.
Move the Pointer to the
language that you want
to set, and then press
the SELECT button.
SETTING
Ceiling
When this function is “On,” the top / bottom and the left / right
reversed picture is provided to project the image from a ceiling
mounted projector.
Rear
When this function is “On,” the left / right reversed picture is provided
to project the image to a rear projection screen.
Ceiling function
Rear function
Split wipe
Turn this function “On” in the SETTING MENU. The picture will
change into next one by sliding black image side ways like drawing
the black curtains when the input source is turned into another one.
Remote control
This projector has two different remote transmit codes; the factory-
set normal code (Mode 1) and the secondary code (Mode 2). This
switching function prevents the remote control operation mixture
(jam) when operating several projectors or video equipment together.
When operating the projector in “Mode 2,” both projector and
Remote Control must be switched to “Mode 2.”
To change the code of the projector;
Set the Remote control in the SETTING MENU to “Mode 2.”
To change the code of the Remote Control;
Press both the MENU and the NORMAL buttons on the Remote
Control together for over 10 seconds.
After changing the code, make sure the Remote Control operates
properly.
To return to the normal code (Mode 1), operate both projector and
Remote Control in the ways above again.
NOTE : When the ALL-OFF switch on the Remote Control Unit is
turned to “ALL-OFF,” the remote transmit code automatically
returns to the normal code (Mode 1).