Filter
Top Products
1
Installing on the Ceiling
Pushing the base plate lock (A), open the
base plate in the arrowed direction.
1
Pass the connection cables through the
cable hole on the base plate.
2
Position the arrow (2) on the base plate
in the direction of the lens.
3
Set the base plate on the ceiling and
tighten it securely using suitable screws
and washers (B).
• Length: 35 mm or more
• Diameter: 3.5 to 5.0 mm
• Height of screw head: 5 mm or less
(washer included)
Push the excess of connected cables into
the ceiling. For details on the connections,
see page 5.
Aligning the ribs (C) and hook (D) on the
camera unit with the slot on the base plate,
push the camera unit until it clicks.
1. Remove the base plate from the
camera unit
2. Install the base plate
Make sure to tighten the screws properly.
Using screws of sizes other than
specified may cause the unit to fall.
A
B
B
1
2
3. Connect the cables from the ceiling
4. Mount the camera unit to the base
plate
Make sure that the camera unit and base
plate fit perfectly.
C
D
L5BM2_XE(INSTALLATION).book 1 ページ ２００６年７月６日 木曜日 午後２時２４分