SATO DR300 Label Maker User Manual


 
DR300 Quick Guide Pg 2
What You Get
The DR300 printer comes packed in a protective carton.
Included in the carton are the following items:
DR300 Printer
Quick Guide
Driver / Manual CD-Rom
2-Pin Power Cable or 3-Pin Plug
Head Cleaning Sheet
Sample Ribbons
Ribbon Take-up Core
Cleaning Solution
Cleaning Cloth
Ribbon Part List
Maintenance Contract
After taking the DR300 Printer out from the carton and
removing the protective plastic cover, it is ready for
installation.
Installation and Handling Instruction
Place of installation
Place on level surface
Avoid vibration
Avoid high temperature and humidity
Avoid high environment
Power Supply
AC220/240V power supply is needed
Supply electricity from main power supply
Three pin earthed power lead is required
A maximum of 3 amp fuse link is recommended
DR300 Quick Guide Pg 31
DIP-Switch Setting
DIP-Switch Setting
DIP Switch shall be set when printer is off.
Each DIPSW setting is described below.
*All are set to OFF position as factory defaults.
No. Setting Content
ON Data bit No. = 7 1
OFF Data bit No. = 8
2
3
Separate
Sheet 1
Parity setting (None, Even, Odd)
4 ON
OFF
Stop bit = 2
Stop bit = 1
5
6
Separate
Sheet 2
Baud rate setting (2400, 4800, 9600, 19200)
7
8
Separate
Sheet 3
Protocol setting (Ready/Busy, Xon-Xoff, Status-3)
Separate sheet 1 (Parity setting)
2 3 Content
ON ON (Reserved)
ON OFF Odd
OFF ON Even
OFF OFF None
Separate sheet 2 (Baud rate setting)
5 6 Content
ON ON 2400 bps
ON OFF 4800 bps
OFF ON 19200 bps
OFF OFF 9600 bps