SATO 608e Printer User Manual


 
MEMORY->CARDCOPY
ALL <XMB> Y/N
This selection allows you to copy the entire contents of the
optional Expanded Memory to the PCMCIA Memory card
installed in the Memory Card slot on the rear of the printer.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the Card to
Memory Copy All mode.
COPY START
YES NO
2. Confirm your selection by stepping the underline cursor to
the Yes selection. If you select No, the display will return
to the previous selection.
MEMORY->CARD
COPY
COPYING
3. Press the FEED key to accept the selection. If Yes was
selected the copy process will start
MEMORY->CARD
COPY
COMPLETED
4. Once the copy process is completed, press the FEED key
to step the display.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was regognized
Mem Full Error Indicates that there is insufficient
memory available.
CARD->MEMORYCOPY
PROGRAM Y/N
This selection allows the user to copy printer firmware from
the PCMCIA Memory Card to the printer.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the mode
display.
COPY START
YES NO
2. Confirm your selection by stepping the underline cursor to
the Yes selection. If you select No, the display will return
to the previous selection.
CARD->MEMORY
COPY
COPYING
3. Press the FEED key to accept the selection. If Yes was
selected the copy process will start
CARD->MEMORYCOPY
COMPLETED
4. Once the copy process is completed, press the FEED key
to step the display.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was regognized
Mem Full Error Indicates that there is insufficient
memory available.
MEMORY->CARDCOPY
PROGRAM Y/N
This selection allows the user to copy the current firmware
installed in the printer to a PCMCIA Memory Card.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the mode
display.
SATO CL Series “e” Printers PN 9001074 Rev. B Page 3-17
Section 3. Configuration