Filter
Top Products
63230-216-207/A3 Appendix C—Using a Crossover Cable to Configure the Power Server
9/2002
33
© 2002 Schneider Electric All Rights Reserved
APPENDIX C—USING A CROSSOVER CABLE TO CONFIGURE THE POWER SERVER
If you choose to use a cross-over cable to configure the Power Server, follow
these steps:
1. Connect the cross-over cable from the Ethernet UTP port on the Power
Server to your PC as illustrated in Figure C–1.
Figure C–1: Cross-over connection for Power Server configuration
2. Connect the power supply and ground if you have not already done so.
For instructions, refer to the section “Control Power” on page 10.
3. From your PC’s taskbar, click Start > Settings > Network and Dial-up
Connections.
The Network and Dial-up Connections screen displays.
NOTE: An example using Microsoft Windows
®
2000 is shown in the
following steps. For help with other systems, contact your network
administrator.
4. From the Network and Dial-up Connections screen, click the Local Area
connection icon.
The Local Area Connection Status dialog box displays.
Cross-over cable
Ethernet
UTP port
30703012
30703006