Filter
Top Products
Installing the Dense QAM Array PSU
Introduction
The PSU is positioned in the right most PCB slot of the Continuum DVP™ Dense
QAM Array Chassis or of the Mercury™ Dense QAM Array Chassis. The following
illustration shows the PSU slot in the chassis.
PSU Module position
1 2 3 4 5 6 7 8
Observe the following cautions when installing the PSU.
CAUTIONS:
During installation, the connector on the PSU must line up evenly with the
connector inside the card slot. When inserting the unit into the module slot,
ensure that the unit is level and the top and the bottom sides slide evenly into
the slot.
PSU contains static-sensitive devices. Always follow proper electrostatic
discharge (ESD) handling procedures (wristband with ground strap and ESD
mat) when installing cards in your chassis. Follow Electronic Industries
Association (EIA) standard EIA-625.
Continued on next page
2-2 Installation 6984278 Rev A