Filter
Top Products
Internet Service: Install USB Drivers, Continued
Microsoft Windows 2000
Follow these steps to install the WebSTAR cable modem USB drivers for Microsoft
Windows 2000 environments.
1.
Insert the USB Cable Modem Driver Installation Disk into the CD-ROM
drive of your PC.
2.
Wait until the POWER and CABLE lights on the cable modem appear solid
green; then, plug the USB cable into the USB port on your PC.
Result: The Found New Hardware Wizard window opens.
3. In the Found New Hardware Wizard window, click Next.
4.
In the Found New Hardware Wizard window, select Search for a suitable
driver for my device (recommended), then click Next.
5.
In the Found New Hardware Wizard window, select CD-ROM drives, and
then click Next.
6. In the Found New Hardware Wizard window, click Next.
Result: The system searches for the driver file for your hardware device.
7.
After the system finds the USB driver, the Digital Signature Not Found
window opens displaying a confirmation message to continue the installation.
8. Click Yes to continue the installation.
Result: The Found New Hardware Wizard window reopens with a message
that the installation is complete.
9. Click Finish to close the Found New Hardware Wizard window.
Result: The USB drivers are installed on your PC and your cable modem is
ready for use.
Note: If you cannot access the Internet, contact your cable service provider
for further assistance.
Continued on next page
4004041 Rev B WebSTAR DPX2203 or EPX2203 VoIP Cable Modem User’s Guide 27