Filter
Top Products
SEAGATE 1200 SSD PRODUCT MANUAL, REV. A 47
8.8 POWER REQUIREMENTS
The standard drive models and the SED drive models have identical hardware, however the security and encryption portion
of the drive controller ASIC is enabled and functional in the SED models. This represents a small additional drain on the 5V
supply of about 30mA and a commensurate increase of about 150mW in power consumption. There is no additional drain on
the 12V supply. See the tables in Section 6.3 for power requirements on the standard (non-SED) drive models.
8.9 SUPPORTED COMMANDS
The SED models support the following two commands in addition to the commands supported by the standard (non-SED)
models as listed in Table 15:
• SECURITY PROTOCOL OUT (B5h)
• SECURITY PROTOCOL IN (A2h)
8.10 SANITIZE - CRYPTOGRAPHIC ERASE
This command cryptographically erases all user data on the drive by destroying the current data encryption key and
replacing it with a new data encryption key randomly generated by the drive. Sanitize CRYPTOGRAPHIC ERASE is a SCSI
CDB Op code 48h and selecting the service action code 3 (CRYPTOGRAPHIC ERASE).
8.11 REVERTSP
SED models will support the RevertSP feature which erases all data in all bands on the device and returns the contents of all
SPs (Security Providers) on the device to their original factory state. In order to execute the RevertSP method the unique
PSID (Physical Secure ID) printed on the drive label must be provided. PSID is not electronically accessible and can only be
manually read from the drive label or scanned in via the 2D barcode.
8.12 SANITIZE FEATURE SET ON SED DRIVES
The drive shall support the Sanitize Feature Set as defined in ANSI/INCITS ACS-2 with the exceptions and/or modifications
described in this section.
The drive shall not support the OVERWRITE EXT and BLOCK ERASE EXT sub-commands.
Support of the SANITIZE FREEZE LOCK EXT command shall be determined on a customer-specific basis. OEM drives
shall support the command.