Filter
Top Products
Barracuda ATA Family Installation Guide, Rev. A 13
4. Select either
(E)asy Disk Installation or (A)dvanced Disk
Installation.
Disk Manager lists all the hard drives that it detects. You
should see your new Seagate drive and your existing hard
drive, if any.
If any hard drive is not recognized, exit Disk Manager and
turn off your computer. Check all cables, jumpers and BIOS
settings. Then start at step 1 to run Disk Manager again.
5. If Disk Manager recognizes all your drives, select the drive
you want to install and press
ENTER
. Disk Manager partitions
and formats the drive.
Important. If your BIOS does not support drive capacities
greater than 8.4 Gbytes, Disk Manager installs a
Dynamic Drive Overlay (DDO)
on your hard drive. If
this driver has been installed, you should see a blue
Disk Manager banner each time you boot your com-
puter. See the Disk Manager online manual for
details.
6. Follow the instructions in the post-installation screens.