Filter
Top Products
2 Barracuda ATA Family Installation Guide, Rev. A
What you need
•
Straight-edge and Phillips screwdrivers
•
Four 6-32 UNC drive mounting screws
•
A standard 40-pin ATA interface cable,
or
an 80-conductor
cable to run Ultra ATA 66 (max length: 18 inches)
•
An unused drive power cable for your new drive
Ultra ATA/66 Requirements
The drive can support transfer rates up to 66 Mbytes per second
in Ultra ATA/66 mode. For your drive to run in this mode you
need the following:
•
A computer that supports UDMA modes 3 and 4
•
A 40-pin 80-conductor cable (maximum length 18 inches)
•
A software utility to activate Ultra ATA/66. Seagate provides a
utility called UTA66.exe that is included on your CD, or you can
download it from our Web site at www.Seagate.com.
•
The Windows 98 operating system
Before you begin
•
Make sure your computer is turned off before you open the
case.
•
Read the handling precautions at the right and inspect the
drive to make sure that it is not damaged.
•
Save your foam-lined Seagate
disc drive box. This box has
been approved by Seagate for shipping a Seagate disc drive.
Using any other container or packing material voids your drive
warranty.