Filter
Top Products
Chapter 3 Installation
Page 16 STT8000A Product Manual
Setting jumpers
Review the jumper settings to ensure that the jumpers are properly configured for
your system. Figure 3-1 shows the location of the jumper block. Figure 3-2 shows
the jumper block.
Note:
Record your jumper settings prior to installation. They are not visible after
the drive has been installed.
The default setting is Slave mode with a jumper over pin 3 and pin 4.
Your system setting may vary, so be sure to check your computer or ATAPI
controller manual to determine the proper configuration choice for your system.
Figure 3-1
Location of jumper block and connectors
IDE
CONNECTOR
IDE PIN 1
POWER
CONNECTOR
NOTE:
Bottom of drive shown.
JUMPER
BLOCK
PIN 1
Figure 3-2
Jumper block and jumper settings
64
3
2
1
8
NOT USED
MASTER
SLAVE
CABLE SELECT
JUMPER ON
JUMPER OFF
75
(TOP OF TAPE DRIVE)