Filter
Top Products
5
ProSEAL
®
44 Pouch Board Laminator
1. Read all instructions before connecting or
operating this unit.
2. Retain this Owners Manual for future
reference. For technical assistance
beyond what is covered in this manual
contact Technical Service.
3. Save your carton! ProSEAL laminators
are shipped in special cartons and should
be used in case your ProSEAL laminator
should ever require service or need to be
transported.
NOTICE! Failure to return machines
properly packed in original packaging
will impose a fifteen percent
restocking fee plus costs to repair
shipping damage. Contact Technical
Service for a return authorization (see
rear cover).
WARNING! Do not modify the plug in
any way.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic
precautions should always be taken to reduce
the risk of electrical shock and injury to
persons, including the following:
NOTE: Disconnect the laminator from the
main power supply before cleaning!
6. Do not immerse any part of the
laminator in water or other liquids.
7. This unit should be situated away from heat
sources such as heat register or
stoves/ovens.
8. The laminator's location or position should
not interfere with its proper ventilation. Do
not install or place in a built-in enclosure
such as a bookcase.
9. Do not operate the laminator with a
damaged cord or plug, or after the laminator
has been dropped or damaged in any
manner. If purchased in U.S./Canada,
return the laminator to SEAL Graphics or if
purchased in Europe or Asia, return to your
ProSEAL reseller for examination, repair or
adjustment.
10. Do not let the cord hang over the edge of a
counter/bench or touch hot surfaces.
11. Always unplug the laminator when it is not
in use for a long period.
12. This unit should only be connected to a
power supply outlet of the voltage,
amperage, and frequency marked on the
rear panel. The laminator has a grounded
plug (three prongs). To reduce the risk of
electrical shock, this plug is intended to fit
only a grounded outlet of the proper
amperage, and in only one way. If it does
not fit in the outlet, contact a qualified
electrician.
4. Do not use the laminator for other
than its intended use.
5. The Laminator case may be cleaned
with a lint-free cloth, lightly
dampened with a mild soap and
water solution. Do not use spray-on
cleaners.