Filter
Top Products
6
ProSEAL
®
44 Pouch Board Laminator
UNPACKING AND SET-UP
The ProSEAL 44 is a professional laminator
designed for ease of use. The process speed
and temperature have been preset to eliminate
operator guesswork. The factory setting will
facilitate good quality results using the
ProSEAL Flexible Pouches and Pouch Boards.
The ProSEAL 44 can handle Flexible Pouches
and Pouch Boards up to 44 inches (1120mm)
wide.
Please familiarize yourself with machine
operation before installation, operating the
Control Panel and the Nip Control Knob.
Installation of your ProSEAL Laminator
Please read and fully understand the entire manual
before proceeding to use your laminator.
Your ProSEAL laminator must be lifted and carried
to the place where it will be used. This should be
done by at least two people, one on each side.
Grasp the machine 8-10 inches (20cm-25cm) from
the side. It should only be placed on a sturdy,
clean, flat, level surface able to support 111 lbs.
(50kg).
Keep the area around your laminator clear with
adequate space around it so you can feed, receive
and trim mounted and/or laminated images.
Unpacking your Laminator
1. Open the box, and lift the machine out (at least
two persons necessary!). Grasp the machine
8"-10" (200mm-250mm) from either side, at
the bottom metal parts. Be careful! The
polyethylene bag is slippery!
2. Place the machine on the work area described
above.
3. Remove the protective expanded polystyrene
foam.
4. Remove the polyethylene bag.
5. Inspect the machine for any physical damage
(if damage does exist, report this to the Freight
Company or Dealer to file a claim). Contact
Technical Service (see rear cover) to
determine if a replacement machine should be
shipped to you.
NOTICE! Retain original packaging. Failure to
return machines properly packed in original
packaging will impose a fifteen percent restocking
fee plus costs to repair shipping damage. Contact
Technical Service for Return Authorization (see
rear cover).
Setting up your Laminator
The ProSEAL laminator should be installed next
to a power/main outlet. If an extension cord is
needed, make sure the cord rating meets or
exceeds the machine rating.
The plug and the outlet must be easily
accessible. Please ensure that you plug your
laminator into a grounded, EARTHED, three-
prong outlet. Please ensure that the total load of
the other items using the same circuit breaker do
not exceed its breaking value.
The US versions of the ProSEAL machines are
provided with a fixed power cable and NEMA
5-15 plug.
Use 120Vac 15A or 20A grounded outlet only.
15A or 20A
Using your ProSEAL 44
• Plug the power cable into the grounded outlet
with appropriate service as described above.
• Turn on power with main power switch. Roller
will turn continuously while power is on.
• Wait 10-15 minutes to determine if the unit
has achieved operating temperature Note:
The LED indicator will blink until the machine
is up to temperature.
• When LED indicator is constantly lit, the
ProSEAL laminator is ready for use.
CAUTION! Set the Nip Control Knob to the
“Open” position when not in use.
NOTE: The laminator may emit vapors the
first few times it is used. This is normal and
will cease after several minutes of use.