Filter
Top Products
7
ProSEAL
®
44 Pouch Board Laminator
NIP CONTROL KNOB
The Control Knob (see figure 1) is located on
the right hand side of the laminator and should
be operated from this side. The control knob is
used to adjust the height of the rollers.
The Nip Settings are 1/4"(6mm), 3/16" (5mm),
1/8" (3mm) and 1/16" (1.5mm) correspond to
Pouch Board thickness. There is also a fully
closed position - 0" (0mm) for future film only
applications. Select the setting that indicates
the thickness of the material you will be using.
To Operate the Nip Control Knob
1. Grasp it with your right hand and push
in approximately 1/4" (6mm).
2. Once the knob has disengaged from the
stop, it may be rotated forward or
backward (clockwise or
counterclockwise, as viewed from the
right hand side of the unit).
3. Once the arrow has reached the desired
nip setting, release the knob or gently
pull the knob out to lock it in place. See
Figure 1A.
Caution! Set the Nip Control Knob to the
“Open” position when not in use.
Figure 1A Nip Control Knob
REAR PANEL
Note: Always switch the power off when the
machine is not in use. The heat is always on
when the main power is on.
In case of Emergency: Turn off the main
power switch or unplug the machine
from the power outlet.
The main fuse is also located on the rear
panel. The main fuse should always be
replaced with the same type. The correct
type is identified on a label above the fuse
holder.
Caution! For continued protection
against risk of fire, replace fuse with
same type and rating.
Figure 1B Rear Panel
To turn the machine on and off, use the main
power switch below in figure 1B.
“O” is off and “1” is on.