Filter
Top Products
35
4
Windows 98/Me/2000
To scan directly into an application using the Button Manager on Windows 98,
Windows Me and Windows 2000. Set the Event Manager properties to send only to
Button Manager as shown below.
1
Click the "Start" button, select "Control Panel" from "Settings",
and open "Scanners and Cameras" in start menu.
2
Select "AL-xxxx" (where xxxx is the model name of your unit)
and click the "Properties" button.
In Windows Me,right click "AL-xxxx" (where xxxx is the model name of your
unit) and click the "Properties" in the menu that appears.
3
In the "Properties" screen, click the
"Events" tab.
4
Click the "Scanner event" button and select
"ScanMenu SC1" from the pull-down menu.
Select "Button Manager (SHARP Personal
MFP Series)" in "Send to this application"
and click "Apply".
5
Repeat step 4 to set "ScanMenu SC2" through "ScanMenu SC6".
Click the "Select an Event" and select "ScanMenu SC2" from the pull-down
menu. Select "Button Manager (SHARP Personal MFP Series)" in "Start this
program" and click "Apply". Do the same for each ScanMenu through
"Scanmenu SC6".
When the settings have been completed, click the "OK" button to close the
screen. When the settings have been completed in Windows, start the
Button Manager. Adjust detailed settings and then scan an image from the
unit. For the procedures for starting Button Manager and adjusting settings,
see "Scan Parameter Settings Dialog Box (p.36)".
In Windows Me, it occasionally happens that the "Scanners and
Cameras" icon does not appear immediately after installation of
the MFP driver is completed. If the icon does not appear, click
"View all Control Panel options" in the Control Panel and display
the "Scanner and Cameras" icon.
If other application are shown,
deselect the checkboxes for the other
applications and leave only the Button
Manager checkbox selected.
SHARP AL-xxxx
SHARP AL-xxxx Properties
SHARP AL-xxxx
SHARP AL-xxxx Properties