Filter
Top Products
50
Automatic exposure adjustment
The automatic exposure level can be adjusted to suit your copying needs. This level is
set for copying from the original table and copying from the SPF/RSPF respectively.
1
When adjusting the automatic exposure level for copying from
the SPF/RSPF, place an original in the original feeder tray and
make sure that the SPF/RSPF ( ) indicator lights up. When
adjusting the level for copying from the original table, make
sure that no original is left in the original feeder tray.
2
Press the exposure mode selector key to
select the photo ( ) mode.
3
Press and hold down the exposure mode
selector key for approximately 5 seconds.
The photo ( ) indicator will go out and
the AUTO indicator will begin to blink. One
or two exposure indicators corresponding
to the automatic exposure level which has
been selected will light up.
4
Press the light ( ) or dark ( ) key to
lighten or darken the automatic exposure
level as desired. If exposure level 2 is
selected, the two left-handmost indicators
for that level will light up simultaneously.
Also, if level 4 is selected, the two right-
handmost indicators for that level will
light up simultaneously.
5
Press the exposure selector key. The AUTO indicator will stop
blinking and light up steadily.
This automatic exposure level will remain in effect until you change it
again by this procedure.