Filter
Top Products
35
6
Copier trouble?
STATUS INDICATORS
When the following indicators light up or blink on the operation panel or the following alphanumeric
codes appear in the display, solve the problem immediately referring to both the table below
and the relevant page.
Steadily
lit
Blinking
Steadily
lit
Blinking
Blinking
Drum replacement
required indicator
Replacement of drum cartridge will be needed
soon. Prepare a new cartridge.
Drum cartridge must be replaced. Replace it
with a new one.
Replacement of TD cartridge will be needed
soon. Prepare a new cartridge.
A misfeed has occurred. Remove the misfed
paper referring to the description of “Misfeed
removal.”
TD cartridge must be replaced. Replace it with
a new one.
TD cartridge
replacement
required indicator
Indication
See
page:
Cause and remedy
“CH” is steadily lit in the
display.
“CH” is blinking in the display.
Misfeed indicator
Paper tray is not securely installed. Push the
tray in securely.
The TD cartridge is not installed. Check if the
cartridge is installed.
Side cover is open. Close the side cover
securely by pressing the round projections
near the side cover open button.
“P” is blinking in the display.
Paper tray or bypass tray is empty. Load copy
paper.
A misfeed has occurred in the paper tray or
bypass tray. Remove the misfed paper.
The copier will not function. Turn the power
switch off, remove the power cord from the
outlet, and contact our Technical Assistance
Department at 1-(630)378-3590 in the USA or
1-877-SHARP-CC (toll free)/905-568-7140 in
Canada.
A letter and a number appear
alternately.
38
27
38
26
31
26
13
—
31
—
—
DISPLAYING TOTAL NUMBER OF COPIES
Use the following procedure to display the total number of copies.
1
Press the clear ( ) key to reset the display to zero.
2
Press and hold down the clear ( ) key for approximately 5 seconds. The total number
of copies will appear in two steps, each with three digits.
Example: Total number of copies is 1,234.
Be sure to use only genuine SHARP parts and supplies.