Filter
Top Products
24
STATUS INDICATORS
1
Open the bypass tray. Lift slightly on the side cover and
slide the cover out until it stops.
2
Push gently the right side of the front cover to open the
cover.
3
Lift the TD cartridge lock release lever and pull the
cartridge out until the green strap handle can be grasped
by the right hand. Lift the cartridge by the handle while
supporting it with the left hand at the green label position
to remove it.
●
Dispose of the old TD cartridge in accordance with local regulations.
4
Remove the new TD cartridge from the bag. Hold the
cartridge on both sides and shake it horizontally four or
five times.
TD CARTRIDGE REPLACEMENT
If the machine detects an insufficient amount of toner being added, copying
will stop and the machine will add toner. During this time the START key
indicator will blink. When sufficient toner has been added the indicator will
remain on steadily indicating that copying can be resumed. However, if
toner addition continues for a maximum of two minutes, the TD cartridge
replacement required ( ) indicator will light up in addition to the START
key being lighted steadily. This indicates that the toner supply is low and a
new cartridge will be needed soon. If copying is continued, the copies will
gradually become lighter until the copier stops and the TD cartridge
replacement required indicator begins to blink, indicating that the cartridge
must be replaced. Replace the TD cartridge by following the procedure
below.
For best copying results, be sure to use only
SHARP Genuine Supplies which are designed,
engineered and tested to maximize the life and
performance of SHARP copiers. Look for the
Genuine Supplies label on the toner package.
TD cartridge replacement
TD cartridge lock
release lever
4 or 5 times
GENUINE SUPPLIES