Filter
Top Products
58
OPTIONAL EQUIPMENT
SINGLE PASS FEEDER
(
AR-SP2
)
Using the SPF
●
Be sure to remove any staples or paper clips from the
originals.
●
Damaged or crumpled originals may misfeed in the SPF.
It is recommended that these originals be copied from the
original table.
●
Before placing curled or wavy originals into the document
feeder tray, be sure to flatten them. If not, original misfeeds
may result.
●
For best feeding of originals which have binding holes
punched into them, insert them so that the holes are
positioned to the right or along the side guides.
●
Special originals such as transparency film and tracing
paper should not be fed through the SPF but should be
copied from the original table.
Single pass feeder (AR-SP2)
Stream feeding mode
If the stream feeding mode has been enabled using user program
No. 4, the SPF indicator will continue to blink for approximately
5 seconds after feeding of all originals is completed. While this
indicator is blinking, any new originals placed in the SPF will be
fed and copied automatically. See page 36, USER PROGRAMS.
1
Ensure that no original is left on the original table.
2
Adjust the original guides to the size of the originals.
3
Set the originals face up in the document feeder tray.
●
The SPF indicator will light up. If this indicator does not light up, the
originals are not properly set or the SPF is not properly closed.
●
The ORIGINAL SIZE indicator for the detected original size will light
up, and the paper tray with the corresponding paper size will be
automatically selected.
●
The auto paper select function can be disabled using user program No.
8. If this function has been disabled, use the TRAY SELECT ( ) key
to select the desired paper tray. See page 36, USER PROGRAMS.
●
To copy onto a different size paper, use the TRAY SELECT ( ) key
to make the selection.
●
The bypass tray cannot be automatically selected.
4
Set the number of copies and press the START ( ) key.
●
Press the CLEAR ( ) key to stop copying in the middle of a run.
●
If the offset stack mode is enabled using user program No. 19, each set
of copies will be offset from the previous set in the sort and group
modes.