Filter
Top Products
16
Using the SPF
The SPF is designed to hold up to 50 originals measuring from A5 to A4 and
weighting from 56 to 90 g/m
2
.
1
Make sure that no original is left on the original table.
2
Adjust the original guides to the size
of originals.
3
Set the originals face up in the
original feeder tray.
Use the peep hole (see the illustration at
right) to check the position of the original.
There is an original top edge mark U in the
peep hole. Align the top edge of the original
with this mark.
• Before feeding originals in the original feeder tray, be sure to remove
any staples or paper clips from them.
• Before placing curled or wavy originals into the original feeder tray, be
sure to flatten them. If not, original misfeeds may result.
• The SPF ( ) indicator on the operation panel will light up. If this
indicator does not light up, the originals are not properly set or the
SPF is not properly closed.
• Badly damaged originals may misfeed in the SPF. It is recommended
that such originals be copied from the original table.
• Special originals such as transparency film should not be fed through
the SPF, but should be placed directly on the original table.
• Image loss (max. 4 mm) can occur at the leading and trailing edges of
the copies. Also image loss (max. 4.5 mm in total) can occur along the
other edges of the copies.
• To stop continuous copying using the SPF, press the clear ( )
key.
Original face up
Peep hole