Filter
Top Products
51
7
STATUS INDICATORS
When the following indicators light up or blink on the operation panel or the following alphanumeric codes
appear in the display, solve the problem immediately referring to both the table below and the relevant page.
Be sure to use only genuine SHARP parts and supplies.
Indication Cause and remedy Page
Developer
replacement required
indicator
Steadily
lit
Developer is required. contact your authorised
service representative.
56
Toner cartridge
replacement required
indicator
Steadily
lit
Replacement of Toner cartridge will be needed soon.
Prepare a new cartridge. (AR-208T)
45
Blinking
Toner cartridge must be replaced. Replace it with a
new one. (AR-208T)
45
Misfeed indicator Blinking
A misfeed has occurred. Remove the misfed paper
referring to the description of "MISFEED REMOVAL".
52
The lower side cover may be open. If so, close it. 55
Maintenance
indicator
Steadily
lit
Service by an authorised SHARP service technician
is required.
56
SPF misfeed
indicator
Blinking
An original misfeed has occurred in the SPF. Remove
the misfed originals referring to the description of "E:
Misfeed in the SPF".
55
Power save indicator is steadily
lit.
The unit is in the preheat mode. Press any key to
cancel the preheat mode.
42
The unit is in the auto power shut-off mode. Press the
start ( ) key to cancel the auto power shut-off
mode.
42
The paper tray indicator is
blinking.
The paper tray is not installed properly. Push the tray
into the unit securely.
–
"CH" is blinking in the display.
The toner cartridge is not installed. Check if the
cartridge is installed. If "CH" is blinking even if a
cartridge is installed properly, contact your SHARP
service centre immediately.
–
"CH" is steadily lit in the display.
Side cover is open. Close the side cover securely by
pressing the round projections near the side cover
open button.
–
"P" is blinking in the display.
The paper tray or multi-bypass tray is empty.
Load paper.
8, 10
A misfeed has occurred in the paper tray, single
bypass or multi-bypass tray. Remove the misfed
paper.
52
Paper tray is not securely installed. Push the tray in
securely.
–
A letter and a number appear
alternately.
The scan head locking switch is locked. Unlock the
scan head locking switch and turn the power switch
off/on.
57
A letter and a number appear
alternately.
The unit will not function. Turn the power switch off
and then switch it on, and if there is again an error,
remove the power cord from the outlet, and contact
your authorized service representative.
–
A letter and a number appear
alternately.
The unit will not function. Turn the power switch off
and then switch it on, or when the side cover is
opened and then closed ; and if there is again an
error, check whether or not you forgot to remove the
bundling tape on the cartridge.
–